Common Soldering Problems You Need to Avoid

By | June 23, 2017

If you are a soldering pro, you would know that the job is not an easy one. Whether you prefer to use your hands or modern equipment, this job can be go wrong at certain times. The best way to avoid these problems is to be aware of them. So, take a look at the following to avoid unnecessary soldering problems.

Overheated Joints

Overheated joints occur when the solder has flowed properly. When the joint gets overheated, it can be quite difficult for you to make the repairs due to the residue of the burnt flux. So, firstly, you will have to clear the residue from the joint first.

Solder Bridges

This usually happens when two solder joints melt and create a bridge together. Although this connection might be intended, it can cause a lot of problems for your work. Solder bridges usually occur when you use the wrong level of temperature. This is why it is important to use proper equipment such as a soldering iron. This way, you will be able to control the heat more precisely. This will enable you to avoid the creation of solder bridges.

Too Much Solder

This is the problem that most rookies experience. When binding two metal joints together, you need to make sure that you do not apply too much solder. Some people believe that applying too much solder will actually make the metals stick more strongly. However, this is not the case in reality. So, make sure that you are only applying the correct amount on solder on the metal.

Cold Joints

When the solder does not melt completely, this can happen. If the surface of the joint is rough of lumpy, then you know that it is a cold joint. Since cold joints can crack over time, you need to get rid them off immediately.

Apart from these, you might also experience disturbed joints, insufficient wetting, and untrimmed leads during certain occasions.